CRAFTSMAN 10 Gallon 150 PSI Vertical review
A 10-gallon vertical with 4.0 CFM at 90 PSI and a 150 PSI tank. Craftsman's listing gives no noise rating, so we can't place it on our dB scale.
Affiliate link · we may earn a commission · Affiliate disclosure
Full specifications
| Noise rating | Not published |
|---|---|
| Noise source | — |
| CFM at 90 PSI | 4 |
| CFM at 40 PSI | 5 |
| Max PSI | 150 |
| Tank | 10 gal |
| Horsepower | 1.8 HP |
| Pump | Oil-free |
| Stages | — |
| Power | 120V outlet |
| Duty cycle | — |
| Weight | — |
| Price band | $300–$600 (checked October 18, 2026) |
A dash means the manufacturer doesn't publish that figure. We never estimate one.
Our take
This Craftsman 10-gallon vertical is a straightforward garage compressor: 4.0 CFM at 90 PSI, 5.0 CFM at 40 PSI, a 150 PSI cut-out and an oil-free pump (listed as 1.8 peak HP).
We could not find a published noise rating, so it sits outside our quiet rankings. It earns a place on the 10-gallon page for its 150 PSI tank, which stores more usable air than 125 PSI rivals.
If noise matters, the California Air Tools 10020C delivers more airflow at a stated 70 dB.
Pros
- 150 PSI stores more air than 125 PSI 10-gallon rivals
- 4.0 CFM at 90 PSI
- Wheels and vertical footprint
Cons
- No published noise rating
- Lower CFM than the California Air Tools 10020C
What it can run
With a 30% safety margin, 4 CFM at 90 PSI comfortably covers these tools from our list (nailers assumed at 30 shots a minute):
- Metabo HPT NT50AE2 18-Gauge Brad Nailer (0.025 cu ft per shot)
- Metabo HPT NR90AES1 Framing Nailer (0.09 cu ft per shot)
- Ingersoll Rand 170G 3/8" Air Ratchet (3 CFM average)
- Ingersoll Rand 3101G 1/4" Die Grinder (3 CFM average)
- Ingersoll Rand 119MAXK Air Hammer Kit (2.9 CFM average)
Who it's for, and who should skip it
Best for: Budget 10-gallon garage compressor with wheels.
Buy it if: your main jobs are nailing, inflation and blow-off; you want a pump with no oil to change.
Skip it if: you need to work indoors or near people without hearing protection.
How it compares in its class
- Ranked #2 of 3 in 10 gallon.
- No published noise rating, unlike 2 of the 3 models in that list.
- 4 CFM at 90 PSI against a class median of 5.3 CFM, so below average airflow for the class.
- Price band $300–$600; see every spec side by side in the comparison table.
Ownership tips
- Drain the tank after each use (daily on a shop compressor) to stop rust from the inside.
- The pump is oil-free, so there's no oil to change; keep the intake filter clean instead.
- Plug it straight into a wall outlet and use a longer air hose instead of a long, thin extension cord.
- Test the safety relief valve now and then by pulling its ring briefly, and never adjust or plug it.
General guidance; always follow the owner's manual. More in our maintenance checklist.
CRAFTSMAN 10 Gallon 150 PSI Vertical: quick answers
How loud is the CRAFTSMAN 10 Gallon 150 PSI Vertical?
The manufacturer doesn't publish a noise rating, so we can't place it on our decibel scale. Treat it as typical for its class.
What can the CRAFTSMAN 10 Gallon 150 PSI Vertical run?
With a 30% safety margin it covers Metabo HPT NT50AE2 18-Gauge Brad Nailer, Metabo HPT NR90AES1 Framing Nailer, Ingersoll Rand 170G 3/8" Air Ratchet, Ingersoll Rand 3101G 1/4" Die Grinder, Ingersoll Rand 119MAXK Air Hammer Kit from our tool list, based on 4 CFM at 90 PSI.
Is the CRAFTSMAN 10 Gallon 150 PSI Vertical oil-free?
Yes. The pump is oil-free, so there's no oil to check or change.
What power does the CRAFTSMAN 10 Gallon 150 PSI Vertical need?
It runs from a standard 120V household outlet. For larger units, a dedicated 20A circuit is best; avoid long, thin extension cords.
Spec sources
Where each figure on this page comes from (checked October 18, 2026). We don't present manufacturer figures as our own measurements.
- Amazon product listing: CFM @ 90 PSI, CFM @ 40 PSI, max PSI, tank, horsepower, pump type
Alternatives to consider
California Air Tools 10020C
70 dB · 5.3 CFM @ 90 PSI · $300–$600
Quiet 10-gallon garage compressor for air tools
VEVOR 10 Gallon 2HP Oil-Free
78 dB · 5.3 CFM @ 90 PSI · $150–$300
Low-cost 10-gallon with high CFM